Page 1 of 1
"Hanging" notes
Posted: Tue Nov 08, 2022 11:50 pm
by wshNPC
Is there a setting I can make that would stop some notes from "hanging"?
Re: "Hanging" notes
Posted: Tue Nov 08, 2022 11:50 pm
by windsynthhelp
Typically this should not happen and there’s no setting for it.
A few questions… Does this only happen when playing wirelessly? Does this only happen on one certain Synth or plug-in?
Re: "Hanging" notes
Posted: Wed Nov 16, 2022 7:18 pm
by wshNPC
It happens when I play wirelessly. It has happened on 2 different synths.
Re: "Hanging" notes
Posted: Wed Nov 16, 2022 7:19 pm
by windsynthhelp
Some things to try:
* Re-pair the Panda system. To put the NuRAD in pairing mode, swipe a magnet over the area where the Panda transmitter is located. The LED should start blinking fast. Press blue button on receiver. They should pair up on best available channel with red LED glowing on both units.
* Make sure as little data as possible is sent for breath. Either CC or AT, not both active at the same time. And no hi-res CC.
* Reduce breath data density by increasing interval. (SETUP BR – BR INTERV, increase to higher number like 8 ms or more.)