Page 1 of 1
My DAW (Ableton) is not registering any MIDI input from my NuRAD (running 1.5b9)
Posted: Mon Oct 24, 2022 4:50 pm
by wshNPC
This started suddenly today. Powers on normally, I have tried two different USB cables and two different ports without success. Have also rebooted my computer and powered the NuRAD down as well.
Re: My DAW (Ableton) is not registering any MIDI input from my NuRAD (running 1.5b9)
Posted: Mon Oct 24, 2022 4:51 pm
by windsynthhelp
If the cables you tried are know good and you tried on another computer or USB host without success, my next guess would be the internal USB cable in the NuRAD. You can verify this by opening up the top, disconnecting the internal USB from the Teensy board and connecting the USB cable directly to it. To open the top, press down on the plastic near the thumb screws to relieve tension when undoing them. Same when putting them back.
Re: My DAW (Ableton) is not registering any MIDI input from my NuRAD (running 1.5b9)
Posted: Mon Oct 24, 2022 4:52 pm
by wshNPC
Working fine in my home studio. Must be a problem with the work computer. I will troubleshoot tomorrow but does not appear to be a hardware issue at this time
Re: My DAW (Ableton) is not registering any MIDI input from my NuRAD (running 1.5b9)
Posted: Mon Oct 24, 2022 4:52 pm
by windsynthhelp
No worries! Glad you could eliminate the NuRAD as source of the problem.