New NuRAD with wireless not working

Discussions specific to the NuRAD
Post Reply
wshNPC
Posts: 85
Joined: Tue Aug 30, 2022 10:49 pm

New NuRAD with wireless not working

Post by wshNPC »

Just got my NuRad. I've connected the Panda MIDI module to the PC, and tested that it's working using their utility. It does not respond to playing on the NuRAD – and I'm not seeing any lights to indicate pairing on the NuRAD. Swiping the magnet across the front does nothing. I'm not sure what I'm doing wrong. There is only a single light visible on the front of the instrument – a red light a little to the right of the top RHK. There is no blinking LED near the LH keys (or anywhere else).
windsynthhelp
Site Admin
Posts: 73
Joined: Tue Aug 23, 2022 7:03 pm

Re: New NuRAD with wireless not working

Post by windsynthhelp »

The latest version of the NuRAD WL has switchable power to the wireless transmitter. The NuRAD power switch has three positions where the rightmost is ’OFF’, the mid position is ’ON’ and the leftmost position is ’ON+wireless’. In the leftmost position you should be getting another LED lighting up in there. Hope this helps.
wshNPC
Posts: 85
Joined: Tue Aug 30, 2022 10:49 pm

Re: New NuRAD with wireless not working

Post by wshNPC »

I was looking at the wrong switch diagram. All good now.
Post Reply